| Product Name | 2.5mm Horizontal SMT Connector | AFC25-S**DCA-00 |
| Rated Voltage | 250V AC/DC | |
| Rated Current | 3.0A | |
| Operating Temperature Range | -25+105 | |
| Operating Humidity Range | Below 90% RH | |
| Packing | Inner packing: joint and several, Outer packing: carton. Sealed and secured within the box. |
| Transport Environment Temperature | -20 to +50 |
| Storage Environment | Temperature: -20+50, Relative Humidity: 90%, free from acidic, alkaline, and corrosive gases. |
| Part Name/Material | Base | LCP E130i |
| Part Name/Material | Pin | Brass |
| Part Name/Material | Stator | Brass |
| Appearance | Plastic parts: free from scars, mottling, cracks, burrs, flash, material deficiency, and deformation. Metal parts: smooth, free from rust, oxidation, peeling, blackening, and mechanical damage. |
| Contact Resistance | Max 20m | After mating |
| Insulation Resistance | Min 1000M | Applied 1000V DC for 1 minute between adjacent contacts and between contacts and enclosure. |
| Withstand Voltage | No breakdown and flashover | Applied 1000V AC for 1 minute between adjacent contacts and between contacts and enclosure. |
| Heating Test | Appearance: No damage; Contact Resistance: Max 30m | 96H at +1052, then 1-2H recovery. |
| Cold Tolerance Test | Appearance: No damage; Contact Resistance: Max 30m | 96H at -252, then 1-2H recovery. |
| Moisture Resistance Test | Appearance: No damage; Insulation Resistance: Min 500M; Withstand Voltage: Min 800V AC/min | 96H at 402, 90-96% RH, then 1-2H recovery. |
| Temperature Cycle Test | Appearance: No abnormality; Contact Resistance: Max 30m | 5 cycles of -253 (30min), Room Temp (1H), +1053 (30min), Room Temp (1H), then 2H recovery. |
| Salt Spray Test | Appearance: No damage or corrosion; Contact Resistance: Max 30m | 24H continuous spray with 51% NaCl solution, followed by washing and 1-2H recovery. |
| Weldability | Tin area: 95% | Dipped in 2455 tin solution for 2.50.5 seconds. |
| Soldering Resistance | 1. Plastic parts: no obvious deformation, damage, or blistering. 2. Electrical characteristics must meet specifications. | Tested via 2605 reflow or wave soldering for 51S. |
| Pin Fixing Force | Min 12N | Single pin, tested at 253mm/min. |
| Terminal Retention in Plastic Parts | Min 15N | Single terminal, tested at 253mm/min along wire direction. |
| Mechanical Life | Contact Resistance: Max 30m | 50 cycles of mating/unmating at 10 cycles/min, under no power. |
| Insertion/Pull-out Force | See table below | Tested at 205mm/min, with lock removed. |
