| 3. USE CONDITION |
| Ambient temperature | -40 105 | |
| Applicable Wire Sizes | AWG #2228 | |
| Applicable PC board thickness | 1.6mm | |
| Appearance | Product surface without defect, dirt, crack, and mechanical damage; contact parts without rust, plating oxidation, or peeling. | |
| Exchangeable | Exchangeable with same specification products. | |
| 6. Electrical Performance |
| Contact Resistance | Initial value 20m | Mate connector combination state, apply 20mV max voltage and 100mA max current to adjacent conductors (does not include wire resistance). |
| Insulation Resistance | 1000 M | Apply 500V DC (rms) for 1 minute between adjacent contacts. |
| Withstand voltage | No breakdown or flashover | Apply 1000V AC (rms) for 1 minute between adjacent terminals and ground of mate connectors, leakage current 0.5mA. |
| Rated Voltage | 250V AC/DC | |
| Rated Current | 3A AC/DC | |
| 7. Mechanical Performance |
| Single contact insertion force | 5.5N | Housing together with terminal ends with wafer matched at a rate of 253mm/min. |
| Single contact Withdrawal force | 1.5N | Housing together with terminal ends with wafer matched at a rate of 253mm/min. |
| Terminal crimping Wire strength | 10N (AWG#22), 13N (AWG#24), 20N (AWG#26), 30N (AWG#28) | Axial pullout force at a rate of 253mm/min. |
| Pin Retention Force | 15N | Exerts a force on the pin end at a rate of 253mm/min until the needle exits the seat. |
| Fixed terminals And hole seat | 50N | |
| Durability | Contact Resistance 30m, Appearance: No damage | Mate connectors up to 30 cycles at a maximum rate of 10 cycles/min prior to environmental test. |
| Vibration | Contact Resistance 30m, Current interruption 1 sec, Appearance: No damage | Amplitude: 1.5mm p-p, Frequency: 10-55-10 Hz/min, Period: 2 hours for each direction (X, Y, Z axes). |
| 8. Endurance Characteristics |
| Thermal Aging | Contact Resistance 30m, Appearance: No damage | Connector combination condition placed in a heating oven at 852C for 96 hours continuously. |
| Temperature Rise | Measure temperature rise of contact when maximum rated current is passed. | |
| Humidity | Contact Resistance 30m, Insulation Resistance 1000 M, Appearance: No damage | Connector combination condition placed in a constant temperature and humidity chamber at 402C and 90-95% RH for 96 hours continuously. |
| Temperature cycling | No breakdown or flashover | One cycle: -403C (30min) -> room temp (10-15min) -> 1053C (30min) -> room temp (10-15min). Total 5 cycles. |
| Salt spray | Contact Resistance 30m, Appearance: No damage | Solution: 51% NaCl. Stamping before tin plated for 24 hours. After test, rinse with water and dry naturally. |
| Solder ability | Soldering area 90% | DIP type: Soldering temperature 3505C, Immersion period 30.5S. SMT type: Soldering temperature 2603C, Immersion period 30.5S. Stamping after tin plated for 8 hours. |
| Resistance to soldering heat | Appearance: No damage | Manual soldering: Soldering time 30.5S, Soldering pot 3505C. Wave soldering: Soldering time 30.5S, Soldering pot 2603C. Position: DIP 1.5mm from conductor/fixed piece, SMT 0.5mm from conductor/fixed piece. |
