| Standard Rating | Rated Voltage: 250V
Rated Current: 2.0A AC/DC
Operating Temperature Range: -25+105
Operating Humidity Range: <90% RH | | |
| Contact Resistance | | Plug in connector, test with contact resistance meter. | 20m Max |
| Insulation Resistance | | Apply 1000V DC between adjacent contacts and between contacts and enclosure for 1 minute. | 1000M Min |
| Withstand Voltage | | Apply 1000V AC between adjacent contacts and between contacts and enclosure for 1 minute. | No breakdown and flashover |
| Heating Test | Appearance: No damage
Contact Resistance: 30m Max | Place in +1052 environment for 96H, then recover for 1-2H. | |
| Cold Tolerance Test | Appearance: No damage
Contact Resistance: 30m Max | Place in -252 environment for 96H, then recover for 1-2H. | |
| Moisture Resistance Test | Appearance: No damage
Insulation Resistance: 500M Min
Withstand Voltage: 600V AC/min MIN | Place in 402, 90~96% RH environment for 96H, then recover for 1-2H. | |
| Temperature Cycle | Appearance: No abnormality
Contact Resistance: 30m Max | 5 cycles of -253 (30min), Room Temp (1H), +1053 (30min), Room Temp (1H), then recover for 2H. | |
| Salt Spray Test | Appearance: No damage, corrosion (Hardware should not expose bottom metal of serious corrosion; pre-plated material blanking surface allows slight corrosion not affecting performance.)
Contact Resistance: 30m Max | Continuous spray with 51% NaCl solution for 24H, wash with distilled water, recover for 1-2H. | |
| Weldability | Tin coverage area: 95% | Dip in 2455 tin solution for 2.50.5 seconds. | |
| Soldering Resistance | 1. Plastic parts: No obvious deformation, damage, blistering.
2. Electrical characteristics must meet specifications. | Reflow soldering or wave soldering at 2605 for 51S. | |
| Pin Fixing Force | Single pin: 10N Min | Apply force at pin front end at 253mm/min until pin withdraws. | |
| Terminal Retention in Plastic Parts | Single terminal: 7N Min | Pull terminal out of socket at 253mm/min along conductor direction. | |
| Mechanical Life | Contact Resistance: 30m Max | Plug and unplug 50 times at 10 times/min without power. | |
| Insertion/Extraction Force | See table below | Fit socket and terminal on the same axis with needle seat, remove socket lock. Test speed: 205mm/min. | |
